IN-TR-01. Message displayed "Lock
not Installed".
Solution:
While running the software, if the Lock is not
detected properly a message is displayed on the
screen 'Lock not installed on Machine'. Check
whether the Hardware Lock is connected properly
as per the instructions described in IN-FQ-02
IN-TR-02.
Message displayed "Unknown Error".
Solution:
If the Hardware Lock is not installed ,'Unknown
Error' message is displayed after running the
software. Install the USB or Parallel Port Lock
driver as mentioned in IN-FQ-02.
IN-TR-03.
Message displayed "Debug Assertion Failed". Solution:
If the Active-X components are not registered properly
while installing the software a error will be displayed
'Debug Assertion Failed' on the screen while executing
various commands of Formulator which are as follows:
1. Random Mesh command in the mesh data dialog box
while drawing a mesh.
2. The ModifyARC / ModifyRCC menus in the Edit Plan
Data option of Floor menu.
In this case run the Register Active-X Components
as explained in IN-FQ-03
IN-TR-04.
Message displayed "Unable to Initialize DAO/Jet
Engine".
Solution:
'Unable to Initialize DAO/Jet db engine' message
is displayed on the screen if the Dao/jet engine
is not initialized properly. Install the MS ACCESS
DAO/ Jet Engine as explained in IN-FQ-04
IN-TR-05.
Message displayed "Failed to create Empty
document".
Solution:
'Failed to Create Empty Document' error message
will be displayed on the screen if the program
is unable to create a new database file. Install
the MS ACCESS DAO/ Jet Engine as explained in
IN-FQ-04
IN-TR-06.
Main Menu Screen doesn't appear.
Solution:
The main menu screen of Formulator doesn't appears
after the title screen If this happens Press Ctrl
+ Alt + Del only once. The Close Program dialog
box will then appear on the screen. Now Select
Formulator.Exe Name and Click on End Task. Check
whether the lock is properly installed or not.
IN-TR-07.
Message displayed "Error during the Move
Data Process:115".
Reason:
Sentry files are read only in windows folder.
Solution:
Go to C:\ Windows from Explorer
1) Arrange the files by ‘Name’
2) Look for the file names starting with ‘sentry’
from the list of files.
3) Select all sentry files & right click in
the blue area.
4) Select ‘Properties’ option.
5) A dialog box appears Undo tick to remove Read
attribute & click OK.
6) Again Run setup.exe program
IN-TR-08. Message
displayed "Error 623".
Reason:
Earlier Installation command was run halfway.
Solution : Delete the Formulator
folder & reinstall.
IN-TR-09. Message
displayed "Cannot Run 16 Bit Application".
Reason:
Problem in your WINDOWS XP Installation.
Solution: Contact your Hardware
Vendor. |